Description

Aussiespeed For 289 302 Ford Windsor 4x IDF Weber intake manifold, This manifold is a sand cast inlet manifold that is cast, machined in Australia.

NOTE NEW MODEL AND NEW PHOTOS AVAILABLE APRIL 2021 THERMOSTAT SIDE OF CARB MOUNTING PADS SWUNG FOR FUEL INJECTION

The new style Aussiespeed AS0302-23 has a centre spiggot for mounting a throttle pivot.

The manifold does not require adapters to bolt carbs or IDF throttle bodies to the manifold as it is machined for them to be bolted straight on.

The older generation AS0302 above could not be used with Jenvey EFI throttle bodies as the carb look fuel injection would have sprayed into the centre of the engine on the thermostat housing side.

The new generation AS0302-23 with its centre mounted linkage spiggot and centre facing carbs on both banks.

Port and water jacket location on our For 289,302 small block manifold.

solid section and under gasket size port faces so the engine builder can get port positioning where they want it.

The manifold can be machined lower to drop the carbs down if required by engine builder.

Available also is part number AS0585 also fits Ford 289/302 Windsor engines and suits IDA weber carbs. 351W Windsor guys we havent forgotten you as an intake for Quad webers is also under development.

CNC port profiling allows for hand finishing ports to suit your cylinder heads